Kitchen · 3 min · Published
Kitchen renovation in Termoli with a switch to induction
An illustrative Termoli kitchen renovation that checked utilities, selected an induction hob and tested the finished installation before handover.
Illustrative scenario · A narrative example of work stages and final checks; it does not document an actual completed project.

Constraints identified before ordering
In this illustrative case, a kitchen renovation in Termoli involved replacing a gas hob with an induction model. The sink and oven would stay in their existing locations. The survey documented the old hob’s supply and the distance between the cabinet and the electrical panel. The initial drawing showed two drawers below the hob. The specification for one appliance under consideration called for a space that this arrangement would occupy. The cabinet was therefore measured with the drawers both removed and in place, so the usable volume and the existing service routes could be recorded together. The measurements went into the comparison before the new appliance was ordered.
Checks with the installers
An electrician assessed the existing electrical installation, its protective devices and the route available for connecting the hob according to the model’s documentation. The appliances likely to run at the same time were identified on site, including the oven and dishwasher. This check took place before selecting the final version of the hob, so normal cooking habits could inform the comparison. A gas technician assessed the line serving the old appliance separately and documented the work needed to take it out of service. Both checks were shown on the same drawing, with distinct references for the electrical route and for the section of gas line affected.
A cabinet planned around the chosen hob
The selected model was added to the kitchen drawing with its cutout dimensions, required clearances and connection position. A template represented its volume below the worktop. In its original position the upper drawer extended too close to the space needed by the appliance. A shallower unit was drawn in a different position, leaving space for the cooking accessories used daily. The worktop finish was then specified using the instructions for the selected appliance and the requirements of the worktop material. The cutting details on the drawing sent to the fabricator were tied to the exact model, avoiding the use of dimensions from an earlier option.
Checks before the cabinet was enclosed
The installers completed their work before the remaining cabinet panels were fitted. During trial fitting, the components that needed to remain accessible were checked and the drawers were run through their travel to confirm that they touched nothing. The upper drawer was tested again with the items it was intended to hold. Photographs taken before closing the cabinet showed the service routes and were kept with the updated drawing. A second inspection checked bearing points and free space against the documents for the appliance that had actually arrived. The finishing components went in after that check, leaving the kitchen ready for a trial in normal use.
Handover with a cooking test
At handover two compatible pans of different sizes were used to test the hob controls. The review covered detection of each pan, the response of the controls and access to the adjacent drawer during the trial. The manufacturer’s instructions remained with the documents supplied by the installers. The handover drawing distinguished the points that could be opened for servicing from the fixed finish panels. The final record also listed the precise hob model so that any later replacement could be checked against the original dimensions and service assessment.
Termoli · CB · Molise · Distance and service-area coverage ↗
How we prepare the guides: sources and illustrative scenarios
