Bathroom · 3 min · Published
Bathroom renovation in Pianella after removing a second bidet
An illustrative case that documented redundant plumbing, repaired the floor and reclaimed space for daily use.
Illustrative scenario · A narrative example of work stages and final checks; it does not document an actual completed project.

Two fixtures in adjacent rooms
In this illustrative case, the Pianella bathroom retained fixtures chosen about fifteen years earlier. A second bidet stood in the adjoining laundry room, occupying a useful stretch for the laundry basket and passage. The first idea was to remove it and put a cabinet against the wall. Before the visit, the household gathered photos of both rooms and a rough drawing of the service routes. The drawing showed which bidet would stay in use and the route people took carrying a basket. The cabinet position remained provisional until the plumber had checked the connections and the section serving the fixture to be removed.
The plumbing survey changed the boundary of the work
After controlled removal, the plumber located the outlets and assessed the section serving the fixture. A connection was visible at a different point from the one shown on the initial drawing. The technician checked that the fixtures to remain could be identified and specified how to take the redundant branch out of use. The locations were photographed before making good. The cabinet moved closer to the doorway to preserve access to a part of the plumbing the plumber had identified. The updated drawing distinguished the redundant points from the components still in use. The file also recorded which parts had been viewed without opening more of the wall.
Choosing how to make good the floor
The tiles below the old fixture had holes and a visible outline. There were enough spares to replace the affected pieces, but one appeared darker in the light from the window. Two arrangements were laid out on a flat surface. In the first, the darker tile fell on the main walking route. In the second, it fell within the strip under the cabinet and the transition near the doorway remained continuous. The tiler checked the substrate and the edge at the wall before confirming the pattern. A photograph of the proposed arrangement stayed with a view of the substrate before it was covered.
Testing with the basket and retained fixtures
The plumber inspected the changes before the finish covered them and tested the retained fixtures. After the tiles went down, the cabinet installer tried the cabinet with the basket in its most obstructive position. The cabinet door opened, but carrying the basket between the laundry and bathroom required stepping sideways. The basket moved to a compartment closer to the wall and the route was tried again. The transition between the repair and retained tiles was also observed while walking through the room. The final photographs showed how to reach the service area without moving the cabinet or taking out fixed shelves.
Planning removal and making good
Before ordering a cabinet, mark which fixture will remain in use and ask the plumber to inspect the connections before closure. Compare spare tiles in the light of the room and trial the layout with the actual basket. At handover, ask to see the checks for the retained fixtures, the parts left accessible and photographs of what is now covered. In this example the household also received the care instructions for the repaired floor and the location of the spare tiles. A copy of the drawing stayed with the plumbing file for later inspections.
Pianella · PE · Abruzzo · Distance and service-area coverage ↗
How we prepare the guides: sources and illustrative scenarios
