Kitchen · 3 min · Published
A fridge beside a pillar in a Miglianico kitchen
An illustrative Miglianico kitchen checks fridge door movement and internal drawer removal beside a pillar.
Illustrative scenario · A narrative example of work stages and final checks; it does not document an actual completed project.

The door opened, but the drawer stayed inside
In this illustrative case, a Miglianico kitchen was renovated with a fridge where a pillar narrowed the wall. The first plan showed that the door would open far enough to take out a bottle. The household asked to test removal of the vegetable drawer because they took it out for cleaning. The supplier checked the movement specified for the model and found it needed more opening room than the plan allowed. The drawing was updated with handle projection, hinge position and the pillar outline at the relevant height. They reconsidered the fridge before ordering the tall cabinet, while there were still several practical options.
The fitter measured the pillar at three heights
The pillar met the plinth in a different place from where it came near the handle. The fitter measured the finished surface and checked where the cabinet side could stand. The professional compared the appliance instructions with opening, airflow and connection clearances. One proposal added a side filler and kept the selected appliance. The other changed the opening direction or type by selecting a compatible fridge. The plan also showed how much worktop would remain for setting down shopping. The comparison made clear which space served door movement and which clearance was needed to remove parts for cleaning.
The filler finish was part of the decision
The supplier drew the wider side and showed how it would appear from the entrance. A cabinet finish made it read as an end panel. A wall colour made it appear closer to the pillar. The household selected a finish after checking the required door travel and access to the parts named in the instructions. They recorded the appliance model and usable opening dimensions. The plan preserved worktop by the entrance and accepted a more visible strip next to the fridge. It also fixed where the plinth and wall finish would end. The remaining trades could then use the same reference rather than working from separate versions of the kitchen layout.
They tested the clearance before fitting the side panel
With base units in place, the supplier checked distance from the pillar against the finished height and verified the delivered appliance. One side trim took up part of the clearance shown on the drawing. The coordinator revised that detail before the final panel was made. The professional confirmed the access and installation conditions for the model. The fitter tried the door with a sample panel in place and checked that the internal drawer could come out. They also tried removing a shelf, which needed a different movement from taking out a bottle. The corrected measurements went on the final drawing with panel position and the nearby edge.
Handover used the fridge as on an ordinary day
During the illustrated handover, the household opened the fridge, put a bag on the adjacent surface and took out an empty drawer for cleaning. They checked whether another person could use the remaining route with the door open. The fitter showed how the door, side and pillar met and left the model references with the plan. The result kept the proposed fridge position and made the relevant interior parts accessible. If the appliance changes, the file gives the next supplier the clearances and actual opening before ordering. The final trial distinguished the opening needed for daily use from the movement needed to clean and maintain the appliance.
Miglianico · CH · Abruzzo · Distance and service-area coverage ↗
How we prepare the guides: sources and illustrative scenarios
