Roofing · 3 min · Published
Repairing a roof valley in San Bartolomeo in Galdo
Two roof slopes drained into a damaged valley. This case follows the inspection and repair while keeping the rest of the roof covering.
Illustrative scenario · A narrative example of work stages and final checks; it does not document an actual completed project.

Clearing debris did not explain the trace below the tiles
In this fictional scenario in San Bartolomeo in Galdo, two roof slopes met at a valley above a utility room. A trace of water appeared near the ceiling after a storm. The fictional client recalled that leaves had previously been removed from the start of the drainage line. The technician wanted to distinguish that earlier accumulation from the current condition of the junction. The contractor arranged a roof inspection with protected access and examined the entire valley. The inspection began at the outlet into the gutter and worked back up the valley, so a defect along the way could be distinguished from an obstruction at the collection point.
A local opening revealed a fold on the upper side
When the contractor arrived, the valley outlet into the gutter was clear. Farther up, a tile along the side exposed an uneven edge on the valley lining. The technician noted its position before approving a local opening. Beneath the removed section, there was a distorted fold near an overlap and a moisture mark behind that edge. The condition to either side was inspected to establish where the affected section ended. The opening did not extend into areas of roof covering that the survey had found intact. The photographs showed the clear outlet and the defect upstream in the same sequence, explaining why the project addressed the junction instead of ending with another cleaning visit.
The replacement followed both pitches
The survey recorded the different pitches to either side and the position of the end tiles. A formed component was prepared for the section being repaired, compatible with the retained lining and the technician's detail. The decision depended on the shape the piece needed to hold between the two slopes, rather than its colour from ground level. The drawing showed the meeting point with the lower component, which would receive the runoff. The contractor checked the fit dry before permanently removing the old piece. At that stage the position of an edge tile was corrected because it would have reduced the channel width available for the designed water path.
The junction was checked before the tiles went back
The contractor cordoned off the area below and arranged removal for suitable weather. Once the valley was open, the crew checked the bearing surface for the new component and showed the technician the condition of the retained parts. Installation restored the route drawn towards the gutter. Before the tiles went back, the technician compared the junction with the survey and photographed the overlaps. The covering to either side was also checked for its effect on the unobstructed channel. The exterior visit ended with a check of the outlet from the protected work position. The room below stayed accessible so the trace could be monitored without crossing the cordoned-off area.
Handover mapped the accessible components
The handover photographs followed the runoff path from the upper section to the gutter. The record showed which component had been replaced, which tiles had gone back to their original positions and where the previous lining remained. The technician left a dated image of the ceiling so the trace could be compared in the following weeks. The fictional homeowner also received the outlet location to pass on to the contractor during future inspections. The record distinguished channel maintenance from the repair just completed. If another interior trace appeared, its documented position could be compared with the original one before any other area of the covering was opened.
San Bartolomeo in Galdo · BN · Campania · Distance and service-area coverage ↗
How we prepare the guides: sources and illustrative scenarios