Parquet · 3 min · Published
Parquet and skirting along a curved wall in Pescara
An illustrative case that traced a curved wall, planned the parquet edge and tried a skirting profile around the bend.
Illustrative scenario · A narrative example of work stages and final checks; it does not document an actual completed project.

The curve looked regular on the drawing
In this illustrative case, parquet in a Pescara hallway had been laid about fifteen years earlier. A curved section of wall linked the corridor and living room. The old skirting used short segments, and several joints were visible from the doorway. During the renewal, the household asked for a more continuous profile. The initial plan showed a regular arc. Measurements on site revealed that the wall changed direction near the living room end. The profile, bearing points and transition to the straight skirting were photographed. The flooring installer asked to inspect the parquet edge before choosing the piece that would cover it.
The template followed several points on the wall
After the old profile came away, the team measured the board edge and wall shape at several points. A small area receded from the initial drawing. The installer recorded the edge and compared it with the clearance required for the flooring system. The fitter made a template and marked where the transition to the straight sections would start. The first rigid sample touched the wall at two points but left a visible gap in the middle. The observation was repeated at skirting height as well as at floor level. This established which shapes could be tried along the whole curve.
Viewing two options from the living room
The fitter compared a profile suited to following the wall with an assembly of shaped pieces. The first reduced the number of joints and required a finish check where it met the straight profile. The second offered independent pieces, but one joint fell in the main sightline from the doorway. The household viewed both samples from the living room and corridor. The first profile was selected after checking its instructions and fitting detail. The drawing kept the skirting independent of movement in the parquet. Both transition points were transferred to the template before the material was ordered for the final installation.
Checking the original view from the doorway
Before completing the finish, the fitter offered up the profile along the curve. Near the living room, the transition cast a wider shadow than it had in the sample. The bearing point was checked and the detail corrected before final installation. The flooring installer inspected the edge before it was covered. After work, the team checked the walking route, whether a cloth could reach the edge and how the curve met the straight sections. The photographs showed the curve from the same position used at the start. The drawing kept the places where the actual wall differed from the initial arc.
Planning skirting for a curved wall
Photograph the existing joints from the doorway and ask the installer to inspect the parquet edge after removal. Have the wall measured at skirting height and compare samples along the whole curve, including the transitions to the straight sections. At handover, check the edge up close and from the main viewpoint. Keep the template and care instructions. This example recorded the selected profile and the photographs of the exposed edge. A future repair could use the actual wall shape and the original installation references rather than relying on the ideal arc drawn at the start of the renovation.
Pescara · PE · Abruzzo · Distance and service-area coverage ↗
How we prepare the guides: sources and illustrative scenarios
