Parquet · 3 min · Published
Small holes in parquet after moving a bed in Cappelle sul Tavo
An illustrative case in Cappelle sul Tavo that examined holes left by fitted furniture and compared finish options.
Illustrative scenario · A narrative example of work stages and final checks; it does not document an actual completed project.

Holes appeared when the bed moved
In this illustrative case, parquet in a Cappelle sul Tavo bedroom had been laid about fifteen years earlier. A fitted bed base covered most of one wall. Removing it during a room renovation exposed several holes and a less glossy outline across the boards. The household wanted to move the bed to another side and leave the strip open. The holes were photographed with the floor dry and located against the board joints. One hole near the wall looked different from the others. The installer kept pictures of the original bearing points so the fixings could be distinguished from other marks.
Separating holes, joints and finish marks
The flooring installer examined the surface and compared the openings with the drawing of the removed base. Several matched fixing points, while the one near the wall belonged to an earlier repair the household did not remember. The inspection included board edges and stability in the affected area. The available documents identified the floor and its finish but gave no record of later work. The installer assessed which holes could receive a compatible local repair and whether any area needed wider examination. The drawing separated repair points from the existing lines between boards, which fell outside the agreed work. It also recorded the area that had stayed covered.
Dry samples in the bedroom light
The installer prepared samples away from the floor and viewed them beside a section that had stayed beneath the base. One colour looked close in shade but became darker in the light from the window. Its gloss was compared with an area already exposed to use. The plan retained the stable boards and selected a local repair after checking the material. The household accepted that the work might remain visible up close. The new bed position used feet tested separately. The repaired strip stayed open for observation, and no furniture foot fell on the spot nearest the joint.
Observing the finish before bringing the bed back
Once the time required by the repair system had passed, the installer checked the points with the floor dry. Side light revealed a difference at one edge that the first photograph taken straight on had missed. The surface was inspected before the room went back into use and photographed from the survey position. A separate trial checked access for cleaning near the wall, where the new bed left a passage. The furniture fitter tried the feet and recorded their position. The final sheet showed which points were repaired and which gloss marks remained visible beyond the old bed.
Planning repairs after removing fitted furniture
Before a fitted base comes out, photograph its bearing points and keep any flooring records. After removal, show the installer which holes correspond to fixings and ask for the boards and finish to be checked. Compare the dry samples from the doorway and window. At handover, review the repairs before putting furniture back and retain the care instructions. In this example the file collected photographs of individual points and the repair material reference. A later touch-up could therefore start from the same survey. The final photograph recorded the clearance between the new bed and the repaired strip.
Cappelle sul Tavo · PE · Abruzzo · Distance and service-area coverage ↗
How we prepare the guides: sources and illustrative scenarios
