Casa Pescara Italiano

Painting · 3 min · Published

Painting sliding wardrobe fronts in Pescara

An illustrative case about sample finishes, overlapping edges and testing sliding doors after repainting.

Illustrative scenario · A narrative example of work stages and final checks; it does not document an actual completed project.

Sage green wall and paint colour samples
Illustrative image

The old colour appeared between the doors

In this illustrative Pescara case, a fitted wardrobe had been finished about fifteen years earlier. The fronts showed marks near the handles but the doors still slid. The brief was to paint the visible face. At the survey, a strip of old colour appeared only when the doors overlapped halfway through their travel. With the wardrobe shut, it stayed hidden. The decorator asked to move both doors from end to end and showed the fitter which edges to examine. Before deciding where the paint would stop, the team photographed the overlap, the handles and the stretch close to the track.

Separating the visible faces from the moving parts

The wardrobe fitter identified the faces that could be reached, the contact areas and components to keep outside the paintwork. The edge between the two fronts had a small worn stretch where someone gripped the door. The decorator checked the existing finish and prepared a sample to compare next to the handle. The drawing showed where the old colour remained visible and where the track had to stay clear. The first plan extended the colour to a margin close to the moving area. Before approving it, the team tested travel using a mock-up of the boundary while keeping material away from contact points.

A halfway trial changed the boundary

With just one door closed, the sample seemed to cover the strip. Moving both doors to halfway revealed an edge beside the handle of the inner door. The plan changed to separate the visible face from the margin needed for movement. A small stretch of finish followed an existing edge, leaving the track and the points identified by the fitter clear. The trial was viewed with the bedroom lamp on because the reflection changed from the entrance. The paint was chosen after that check. The revised sketch showed what to paint and what to protect across the useful door positions.

Checking travel with the fronts back in place

The surfaces were prepared as agreed and the tracks stayed protected. When the fronts were ready for use, the fitter checked their travel before anything went back into the wardrobe. At handover, both doors opened as far as they did in everyday use. The halfway overlap was viewed and the handle grip checked. The decorator inspected the inner edge with the light on. The record kept the finish reference and photographs of three door positions. The drawing also identified the part kept free of paint for servicing.

Planning a finish that preserves movement

Photograph the doors shut, halfway across and open. Ask the decorator and fitter to identify the faces, tracks and contact areas before making a sample. Try the colour beside the handle under the usual light. After the work, have travel checked and compare the edges with the photographs. Keep the drawing with the care instructions for the finish and track servicing. If a door starts to brush an edge, note where contact occurs before asking for adjustment so the person responsible can reproduce the problem. Ask which parts can be cleaned while the door stays in place and which should be left to the person servicing it. Keep the finish reference for the front separate from the track reference.

Pescara · PE · Abruzzo · Distance and service-area coverage ↗

How we prepare the guides: sources and illustrative scenarios