Kitchen · 3 min · Published
An oven and microwave in one tall cabinet in Lanciano
An illustrative Lanciano kitchen checks the cabinet, airflow and height for removing dishes before the tall unit is ordered.
Illustrative scenario · A narrative example of work stages and final checks; it does not document an actual completed project.

The cabinet looked ready until both installation drawings were overlaid
In this illustrative case, a kitchen in Lanciano was renovated with a built-in oven and microwave in one tall cabinet. The first design used two nominal openings. When the supplier compared the actual models, they saw that the shelf between the appliances occupied part of the room required for airflow. The household wanted the tall unit so they could remove a tray without bending too far. The designer drew openings, air routes, connections and door movement in section. Before approving the cabinet, the installer was asked to review the whole configuration, including where the appliance connections would be reached after fitting.
The check used both appliance instructions
The professional examined the model documentation, wall conditions and space behind the cabinet. The supplier proposed a different shelf to check against both appliances. Another option put the appliances in separate units and freed the upper opening while reducing preparation surface. They compared both with door outlines and an empty dish of the size the household used. A convenient height for reading the controls was different from the height at which it was easiest to remove the dish. The decision included both movements and the route to a place to set it down. Confirmed dimensions went into the drawing before the fronts, back and shelves were specified.
The choice kept the air route identifiable
After checking the manufacturers’ requirements, the final design kept both appliances in one cabinet. The supplier showed where space had to stay clear behind and between them. A full-height side gave a continuous look, with a lower detail that needed to preserve the specified airflow. The household viewed finishes from the entrance and checked the worktop where they could rest a tray. The installer planned connections without using space needed inside the cabinet. The quote listed cabinetry, preparation and appliance fitting separately. When another model was suggested, its instructions were compared with the original requirements before the team decided whether it would fit.
The intermediate check took place with the cabinet open
Before closing the cabinet, the fitter checked each opening with the shelves in position. The professional reviewed clearances and connections under the actual instructions. A small difference beside one shelf was corrected before the appliances went in. The coordinator checked dimensions against labels and recorded the air route on the final drawing. Photographs covered parts that would become hidden. The team tried the empty dish in front of the cabinet and checked the opening of the nearby front. Appliance installation followed those checks, when the drawing and cabinet described the same configuration. This also left a record of how the two models fitted together.
Handover followed the route from the oven to the worktop
At the illustrated handover, the installer checked operation and showed which spaces needed to stay clear. The household simulated removing a cold tray and set it on the worktop reserved for that purpose. They tried the movement while another person stood near the column. The coordinator checked front alignment and access to the points in the instructions. The file kept both appliance sheets and the finished section. The arrangement preserved the preparation surface and assigned each opening the conditions for its specific model. When an appliance changes, the record will help the next installer check dimensions, airflow and access together before the replacement is ordered.
Lanciano · CH · Abruzzo · Distance and service-area coverage ↗
How we prepare the guides: sources and illustrative scenarios
