Casa Pescara Italiano

Kitchen · 3 min · Published

Kitchen renovation in Montesilvano with a pet feeding station

An illustrative Montesilvano kitchen renovation with a washable feeding niche and a clear route between the entrance and kitchen.

Illustrative scenario · A narrative example of work stages and final checks; it does not document an actual completed project.

Timber kitchen with a pale stone island
Illustrative image

A route used throughout the day

In this illustrative case, the kitchen in Montesilvano opened directly onto the entrance corridor. The dog’s bowls stood beside the fridge, where anyone carrying groceries into the home needed to pass. Before the renovation, photos recorded where the feeding mat tended to slide and the dog's usual route from the entrance to its resting area was marked out. The planned niche beneath the new cabinets would free up the corridor. It still needed to give the animal room to lower its head comfortably and let someone lift a full water bowl without tipping it onto the floor.

Choosing the open cabinet

The survey ruled out the end unit next to the fridge because the appliance door swung across that part of the room. A unit by the blank wall was selected, outside the space required for opening the oven. The compartment for the bowls contained no sockets, ventilation grilles or plumbing connections. A closed compartment above it remained available for a container of clean accessories. A cardboard mock-up reproduced the opening and depth. Each bowl was lifted out in turn and a grocery bag was set down at the spot normally used for unloading, so the arrangement could be checked in daily use.

An edge to contain splashes

The detail drawings distinguished the fixed cabinet base from the removable tray, which could be carried to the sink. A tray with rounded corners was selected after measuring the space occupied by the bowls when full. Smooth panels with protected edges lined the niche, with the finish matched to the cleaning requirements for the chosen material. The floor continued across the front of the unit without a step. End pieces closed off the adjacent cabinet plinths, leaving the feeding space separate from the void beneath the rest of the kitchen. The tray and bowls could therefore come out as a set.

Checks after cabinet assembly

Before the finishing pieces were fitted, the adjacent cabinets went in and the tray was tested at the actual opening height. The initial shelf position let the bowls through but left too little room for a hand to pick up the one farther back. The shelf was raised before the upper enclosure was prepared. Clearances at the neighbouring doors were checked, and the entrance-to-fridge route was walked with a bag while the niche was in use. No loose edges projected onto the floor where people would step, and there was still room to turn in front of the pantry cabinet.

Using cleaning as the handover test

At handover the tray was removed with both bowls empty, washed and replaced after drying. A cloth could reach the corners of the fixed base, and a small spill test confirmed that the water stayed in the tray and away from the cabinet sides. The entrance route was walked again with the cabinet doors shut, followed by a check that the fridge could open fully with the feeding station occupied. The handover notes listed cleaning products compatible with the surfaces and showed where to lift the tray first. A separate mark on the cabinet drawing recorded the location of the food container.

Montesilvano · PE · Abruzzo · Distance and service-area coverage ↗

How we prepare the guides: sources and illustrative scenarios