Casa Pescara Italiano

Home renovation · 3 min · Published

Chieti home renovation with bicycle storage under the stairs

An illustrative case about measuring a space below the stairs, moving its opening and testing bicycle access.

Illustrative scenario · A narrative example of work stages and final checks; it does not document an actual completed project.

Entrance with a stone console and a light living room
Illustrative image

The handlebars only fitted at an angle

In this illustrative case in Chieti, a bicycle stood in the entrance because the space under the stairs had a low opening set to one side. At the survey, the front wheel went through, but the handlebars hit the upper corner as soon as the bike was straightened. The renovation already included making good the walls inside the space. Before deciding how to finish the opening, the team sketched the profile of the cupboard, the angle of the stairs and the shape of the handlebars. The bicycle had a removable basket, but the check kept it attached because it usually stayed on the bike after a ride. The intended route also had to clear the entrance coat rack.

Separating storage from the route in

The space was deep enough for the bike once it was parked. The difficult point was the turn made by the front wheel while the back wheel was still in the entrance. The team measured both the passage and the place where someone stood to guide the bike. The first drawing kept the opening in place and moved the wheel support toward the higher side. The trial showed that this still put the handlebars beneath the corner during the turn. A possible opening closer to the high side was marked before any decision was made about which part of the enclosure to open up.

Reversing out moved the wheel stop

Once the area affected by the work had been checked, a full-size mock-up established the opening. Rolling the bicycle in became easier, but reversing out brought a pedal close to the adjacent wall. The wheel stop moved and turned slightly for the next trial. From that position the bike was already pointing toward the opening when it started moving. A clear spot near the edge was also kept for someone to grip the saddle. The helmet holder proposed for that spot went to the opposite side. Its new position was checked with the bike parked, to make sure the helmet could be reached without moving the wheel.

Finishing after a check of the edges

Once the space was ready, the finished profile was compared with the original mock-up. The team checked how much clearance the new edges would occupy and ran the entry trial before closing up the repairs. The decorator then finished the inside while the wheel stop was still out. It went back on the agreed mark, keeping the route from threshold to parking point clear. The understairs light was switched on to check the newly finished edge and the low area close to the pedal. The basket hanging in the entrance went back only after the first trial with the cupboard empty.

Handover included a bicycle ready to leave

The last trial used the bike with its basket attached, the helmet on its hook and a jacket hanging at the entrance. The bicycle rolled in as far as the wheel stop and came out without touching the repaired edges. The person could close the cupboard after parking and retrieve the helmet while the wheel stayed put. Finally, the arrangement was checked from the other side of the entrance to see whether anything projected into the passage while the cupboard was occupied. The handover sheet recorded the positions of the wheel stop and helmet holder and the outline that had been tested. A photograph of the parked bike showed the orientation used in the check.

Chieti · CH · Abruzzo · Distance and service-area coverage ↗

How we prepare the guides: sources and illustrative scenarios