Casa Pescara Italiano

Bathroom · 3 min · Published

Double basin in a Francavilla al Mare bathroom with one existing outlet

An illustrative case in Francavilla al Mare that checked a double vanity against the position of the existing waste outlet.

Illustrative scenario · A narrative example of work stages and final checks; it does not document an actual completed project.

Travertine bathroom with a walk-in shower
Illustrative image

The cabinet centre and waste outlet differed

In this illustrative case, the Francavilla al Mare bathroom retained finishes installed about fifteen years earlier. A replacement vanity would carry two basins and retain the existing service wall where possible. The old cabinet concealed the point where the waste entered the wall. The initial drawing showed it in the centre, based on the position of the previous basin. A measurement inside the cabinet showed that the connection arrived from one side. Its position stayed provisional until removal. The cabinet drawing was held back from manufacture until the technician could compare the exposed outlet with the space taken up by the two basins.

Planning the routes before the drawers

After removal, the plumber measured the height and position of the outlet. The assessment covered the proposed waste route for each basin, future access and connections suited to the conditions. A cardboard template reproduced the cabinet in plan. The first design left room for the pipework with the drawers closed, but the back of one drawer entered the same space when pulled out. The intended contents were checked too. A tray of accessories occupied the section that had been marked for reduction. The design was revised to show drawers, connections and stored items in use, so their movement could be understood beyond the elevation drawing.

A service compartment on the less visible side

The chosen cabinet had a side compartment reached through a hinged door. The drawing allowed space for the connections identified by the plumber and showed where items could be stored away from the parts that needed inspection. Drawers of different depths occupied the remaining areas. On the top, templates recorded the basin outlines, tap movement and the position of a hand opening the cabinet door. The first worktop sample left little space between one lever and the mirror, so its position changed before cutting. The finish was selected along with the edge and opening details shown by the basin manufacturer.

Checking both basins in use

Before the cabinet interior was completed, the plumber tested each basin separately and then both together while observing the accessible connections. The installer checked the full drawer travel with the intended contents in place. The side door was tried again after a waste bin was set in its usual position. The bin restricted room to approach the connection, so the final drawing moved it. The final checks covered basin stability and whether the edges of the top could be reached during cleaning. The service compartment was photographed before the internal shelf was fitted, so that the exact route remained visible in the records.

A roadmap for adding a second basin

Before ordering the cabinet, ask which measurements will still need confirmation after removal. The handover documents set out the practical sequence: confirm the outlet after removal, have the two fixtures assessed, try the moving parts, test the connections in use and document access. The cleaning instructions distinguished products for the top from those for the cabinet finish. A drawing showed which items could obstruct the door if placed too close. The connection references stayed with the photographs. A future inspection could therefore begin at the planned opening, with the actual waste route visible on the drawing even after it was hidden behind the cabinet front. The same record showed which shelf could be cleared for access.

Francavilla al Mare · CH · Abruzzo · Distance and service-area coverage ↗

How we prepare the guides: sources and illustrative scenarios